|
tapplastics (December 31, 1969 at 6:59 pm)
It depends on how bad the mark is. Your best bet is to try the Novus Scratch Removal System. If the mark is too bad, you will need a new piece of acrylic.
akileo1234 (December 31, 1969 at 6:59 pm)
Is there any way I can remove the marks left on the plastic sheet while welding?
tapplastics (December 31, 1969 at 6:59 pm)
They are available at our website.
speedsk8r010 (December 31, 1969 at 6:59 pm)
Where can i buy acrylic sheets?
tapplastics (December 31, 1969 at 6:59 pm)
Yes, if they are acrylic, the process would be essentially the same. If you are joining two curved areas with very little surface contact, use a thickened cement such as Weld-On #16 Adhesive, available at our website.
Raych1974 (December 31, 1969 at 6:59 pm)
Do you use this same process if you are gluing two round tubes together?
tapplastics (December 31, 1969 at 6:59 pm)
yes.
zaracki92 (December 31, 1969 at 6:59 pm)
can i do tht to make acrylic aquariums?
tapplastics (December 31, 1969 at 6:59 pm)
See the comment above about MAPP gas.
tapplastics (December 31, 1969 at 6:59 pm)
The applicator shown in the video uses a 23 gauge needle which has an inside diameter of .0125". If you order it on our website, it is the small BD 25/2 applicator. |
